The STUPID bolt fell into the hole when I had the Cam shaft position sensor pulled out. I could not get it with a magnet. This is a GM V6 3600. Any chance it will make a clean pass to the oil pan or do I have to open up the entire motor?I dropped the small bolt to hold the Cam position sensor into a 3.3 GM motor. Will it go to the oil pan?
3.3 = 3300 not 3600,I dropped the small bolt to hold the Cam position sensor into a 3.3 GM motor. Will it go to the oil pan?
try a vacuum cleaner fit a small vac hose to the end of the larger hose duct tape helps.then you can push the smaller dia. hose through the same hole the bolt went in.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment